HPE 5920 series User Manual

268
ipv6 dhcp client stateless enable
Use ipv6 dhcp client stateless enable to enable stateless DHCPv6.
Use undo ipv6 dhcp client stateless enable to restore the default.
Syntax
ipv6 dhcp client stateless enable
undo ipv6 dhcp client stateless enable
Default
Stateless DHCPv6 is disabled.
Views
Layer 3 Ethernet interface/subinterface view
Layer 3 aggregate interface/subinterface view
Management Ethernet interface view
VLAN interface view
Predefined user roles
network-admin
Usage guidelines
With stateless DHCPv6 enabled on an interface, the interface sends an Information-request
message to the multicast address of all DHCPv6 servers and DHCPv6 relay agents to request
configuration parameters.
Examples
# Enable stateless DHCPv6 on VLAN-interface 2.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] ipv6 dhcp client stateless enable
reset ipv6 dhcp client statistics
Use reset ipv6 dhcp client statistics to clear DHCPv6 client statistics.
Syntax
reset ipv6 dhcp client statistics [ interface interface-type interface-number ]
Views
User view
Predefined user roles
network-admin
Parameters
interface interface-type interface-number: Specifies an interface by its type and number. If you do
not specify an interface, this command clears all DHCPv6 client statistics.
Examples
# Clear all DHCPv6 client statistics.
<Sysname> reset ipv6 dhcp client statistics

HPE 5920 series Specifications

General

Brand	HPE
Model	5920 series
Category	Switch
Language	English