HPE 5920 series

141
Syntax
ip irdp multicast
undo ip irdp multicast
Default
The destination IP address is 255.255.255.255.
Views
Interface view
Predefined user roles
network-admin
Examples
# Specify the multicast address 224.0.0.1 as the destination IP address for VLAN-interface 100 to
send RAs.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ip irdp multicast
Related commands
ip irdp
ip irdp preference
Use ip irdp preference to specify the preference of advertised primary and secondary IP addresses
on an interface.
Use undo ip irdp preference to restore the default.
Syntax
ip irdp preference preference-value
undo ip irdp preference
Default
The preference of advertised IP addresses is 0.
Views
Interface view
Predefined user roles
network-admin
Parameters
preference-value: Specifies the preference in the range of –2147483648 to 2147483647. A larger
value represents a higher preference. To request neighboring hosts to not use any advertised IP
address as the default gateway, set the value to the minimum value (–2147483648).
Examples
# Specify preference 1 for IP addresses advertised on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ip irdp preference 1