HPE 5920 series

51
Use undo gateway-list to remove the specified gateway addresses from a DHCP address pool or a
DHCP secondary subnet.
Syntax
gateway-list ip-address&<1-8>
undo gateway-list [ ip-address&<1-8> ]
Default
No gateway address is configured in a DHCP address pool or a DHCP secondary subnet.
Views
DHCP address pool view, DHCP secondary subnet view
Predefined user roles
network-admin
Parameters
ip-address&<1-8>: Specifies gateways. &<1-8> indicates that you can specify up to eight gateway
addresses separated by spaces. Gateway addresses must reside on the same subnet as the
assignable IP addresses.
Usage guidelines
If you use this command multiple times, the most recent configuration takes effect.
If you do not specify any parameters, the undo gateway-list command deletes all gateway
addresses.
If you specify gateways in both address pool view and secondary subnet view, DHCP assigns the
gateway addresses in the secondary subnet view to the clients on the secondary subnet.
If you specify gateways in address pool view but not in secondary subnet view, DHCP assigns the
gateway addresses in address pool view to the clients on the secondary subnet.
Examples
# Specify the gateway address 10.1.1.1 in DHCP address pool 0.
<Sysname> system-view
[Sysname] dhcp server ip-pool 0
[Sysname-dhcp-pool-0] gateway-list 10.1.1.1
Related commands
display dhcp server pool
if-match
Use if-match to configure a match rule for a DHCP user class.
Use undo if-match to remove the match rule for a DHCP user class.
Syntax
if-match rule rule-number option option-code [ hex hex-string [ mask mask | offset offset length
length ] ]
undo if-match rule rule-number
Default
No match rule is configured for the DHCP user class.