HPE 5920 series User Manual

294
interface tunnel
Use interface tunnel to create a tunnel interface, specify the tunnel mode, and enter tunnel interface
view.
Use undo interface tunnel to delete a tunnel interface.
Syntax
interface tunnel number [ mode { gre [ ipv6 ] | ipv4-ipv4 | ipv6 | ipv6-ipv4 [ 6to4 | isatap ] |
mpls-te } ]
undo interface tunnel number
Default
No tunnel interface is created on the device.
Views
System view
Predefined user roles
network-admin
Parameters
number: Specifies the number of the tunnel interface, in the range of 0 to 1023.
mode gre: Specifies GRE/IPv4 tunnel mode.
mode gre ipv6: Specifies GRE/IPv6 tunnel mode.
mode ipv4-ipv4: Specifies IPv4 over IPv4 tunnel mode.
mode ipv6: Specifies IPv6 tunnel mode. Set this mode for IPv4 over IPv6 manual and IPv6 over
IPv6 tunnels.
mode ipv6-ipv4: Specifies IPv6 over IPv4 manual tunnel mode.
mode ipv6-ipv4 6to4: Specifies 6to4 tunnel mode.
mode ipv6-ipv4 isatap: Specifies ISATAP tunnel mode.
mode mpls-te: Specifies MPLS TE tunnel mode.
Usage guidelines
To create a new tunnel interface, you must specify the tunnel mode in this command. To enter the
view of an existing tunnel interface, you do not need to specify the tunnel mode.
A tunnel interface number is locally significant. The tunnel interfaces on the two ends of a tunnel can
use the same or different interface numbers.
Examples
# Create a GRE/IPv4 tunnel interface Tunnel 1 and enter tunnel interface view.
<Sysname> system-view
[Sysname] interface tunnel 1 mode gre
[Sysname-Tunnel1]
Related commands
destination
display interface tunnel
source

HPE 5920 series Specifications

General

Brand	HPE
Model	5920 series
Category	Switch
Language	English