HPE 5920 series

235
Predefined user roles
network-admin
network-operator
Parameters
interface interface-type interface-number: Displays DHCPv6 server configuration information for the
specified interface. If you do not specify an interface, this command displays DHCPv6 server
configuration information for all interfaces.
Examples
# Display DHCPv6 server configuration information for all interfaces.
<Sysname> display ipv6 dhcp server
Interface Pool
Vlan-interface2 1
Vlan-interface3 global
# Display DHCPv6 server configuration information for the interface VLAN-interface 2.
<Sysname> display ipv6 dhcp server interface vlan-interface 2
Using pool: 1
Preference value: 0
Allow-hint: Enabled
Rapid-commit: Disabled
Table 56 Command output
Field
Description
Interface Interface enabled with DHCPv6 server.
Pool
Address pool applied to the interface.
If no address pool is applied to the interface,
global
is displayed. The
DHCPv6 server selects a global address pool to assign a prefix, an
address, and other configuration parameters to a client.
Using pool
Address pool applied to the interface.
If no address pool is applied to the interface,
global
is displayed. The
DHCPv6 server selects a global address pool to assign a prefix, an
address, and other configuration parameters to a client.
Preference value
Server preference in the DHCPv6 Advertise message. The value range
is 0 to 255. The bigger the value is, the higher preference the server
has.
Allow-hint Indicates whether desired address/prefix assignment is enabled.
Rapid-commit Indicates whether rapid address/prefix assignment is enabled.
display ipv6 dhcp server conflict
Use display ipv6 dhcp server conflict to display information about IPv6 address conflicts.
Syntax
display ipv6 dhcp server conflict [ address ipv6-address ]
Views
Any view