296
If you do not specify any parameters, this command clears statistics for all interfaces.
If you specify only the tunnel keyword, this command clears statistics for all tunnel interfaces.
If you specify both the tunnel keyword and the number argument, this command clears
statistics for the specified tunnel interface.
Examples
# Clear statistics for interface Tunnel 1.
<Sysname> reset counters interface tunnel 1
Related commands
display interface tunnel
service
Use service to specify a traffic processing slot for a tunnel interface.
Use undo service to restore the default.
Syntax
service slot slot-number
undo service slot
Default
No traffic processing slot is specified for a tunnel interface. Traffic on a tunnel interface is processed
on the slot at which the traffic arrives.
Views
Tunnel interface view
Predefined user roles
network-admin
Parameters
slot slot-number: Specifies an IRF member device by its member ID or specifies a PEX by its virtual
slot number.
Usage guidelines
Specify a traffic processing slot if a feature (for example, IPsec antireplay) requires that all traffic on
a tunnel interface be processed on the same slot.
Make sure the specified traffic processing slot is available. If the specified traffic processing slot is
unavailable, traffic on the tunnel interface cannot be forwarded, whether or not the tunnel interface is
up. Traffic on the tunnel interface will not be forwarded until the traffic processing slot becomes
available or until you respecify an available traffic processing slot.
Examples
# Specify a traffic processing slot for Tunnel 200.
<Sysname> system-view
[Sysname] interface tunnel 200
[Sysname-Tunnel200] service slot 2
shutdown
Use shutdown to shut down a tunnel interface.
Use undo shutdown to bring up a tunnel interface.
To Next Page
Loading...
Need help?
General