HPE 5920 series

280
undo ipv6 dhcp snooping option remote-id enable
Default
Option 37 is not supported.
Views
Layer 2 Ethernet interface/Layer 2 aggregate interface view
S-channel interface/S-channel aggregate interface view
VSI interface/VSI aggregate interface view
Predefined user roles
network-admin
Usage guidelines
This command takes effect only when DHCPv6 snooping is globally enabled.
Examples
# Enable support for Option 37.
<Sysname> system-view
[Sysname] ipv6 dhcp snooping enable
[Sysname] interface Ten-GigabitEthernet1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] ipv6 dhcp snooping option remote-id enable
Related commands
ipv6 dhcp snooping enable
ipv6 dhcp snooping option remote-id string
ipv6 dhcp snooping option remote-id string
Use ipv6 dhcp snooping option remote-id string to specify the content as the remote ID for
Option 37.
Use undo ipv6 dhcp snooping option remote-id string to restore the default.
Syntax
ipv6 dhcp snooping option remote-id [ vlan vlan-id ] string remote-id
undo ipv6 dhcp snooping option remote-id [ vlan vlan-id ]
Default
The DHCPv6 snooping device uses its DUID as the content for Option 37.
Views
Layer 2 Ethernet interface/Layer 2 aggregate interface view
S-channel interface/S-channel aggregate interface view
VSI interface/VSI aggregate interface view
Predefined user roles
network-admin
Parameters
vlan vlan-id: Specifies the VLAN where the DHCPv6 clients resides.
remote-id: Specifies the a string of 1 to 128 characters as the remote ID.