HPE 5920 series

138
IRDP commands
The term "interface" in this chapter collectively refers to Layer 3 interfaces, including VLAN
interfaces and Layer 3 Ethernet interfaces. You can set an Ethernet port as a Layer 3 interface by
using the port link-mode route command (see Layer 2—LAN Switching Configuration Guide).
ip irdp
Use ip irdp to enable IRDP on an interface.
Use undo ip irdp to disable IRDP on an interface.
Syntax
ip irdp
undo ip irdp
Default
IRDP is disabled on an interface.
Views
Interface view
Predefined user roles
network-admin
Usage guidelines
After IRDP is enabled on an interface, the IRDP configuration takes effect, and the device sends RA
messages out of the interface.
Examples
# Enable IRDP on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ip irdp
ip irdp address
Use ip irdp address to specify an IP address to be proxy-advertised by an interface.
Use undo ip irdp address to remove the proxy-advertised IP address.
Syntax
ip irdp address ip-address preference-value
undo ip irdp address [ ip-address ]
Default
No proxy-advertised IP address is specified.
Views
Interface view
Predefined user roles
network-admin