HPE 5920 series User Manual

143
IP performance optimization commands
The term "interface" in this chapter collectively refers to Layer 3 interfaces, including VLAN
interfaces and Layer 3 Ethernet interfaces. You can set an Ethernet port as a Layer 3 interface by
using the port link-mode route command (see Layer 2—LAN Switching Configuration Guide).
display icmp statistics
Use display icmp statistics to display ICMP statistics.
Syntax
display icmp statistics [ slot slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
slot slot-number: Specifies an IRF member device by its member ID or a PEX by its virtual slot
number.
Usage guidelines
ICMP statistics include information about received and sent ICMP packets.
Examples
# Display ICMP statistics.
<Sysname> display icmp statistics
Input: bad formats 0 bad checksum 0
echo 175 destination unreachable 0
source quench 0 redirects 0
echo replies 201 parameter problem 0
timestamp 0 information requests 0
mask requests 0 mask replies 0
time exceeded 0 invalid type 0
router advert 0 router solicit 0
broadcast/multicast echo requests ignored 0
broadcast/multicast timestamp requests ignored 0
Output: echo 0 destination unreachable 0
source quench 0 redirects 0
echo replies 175 parameter problem 0
timestamp 0 information replies 0
mask requests 0 mask replies 0
time exceeded 0 bad address 0
packet error 1442 router advert 3

HPE 5920 series Specifications

General

Brand	HPE
Model	5920 series
Category	Switch
Language	English