297
Syntax
shutdown
undo shutdown
Default
The tunnel interface is enabled.
Views
Tunnel interface view
Predefined user roles
network-admin
Usage guidelines
This command disconnects all links set up on the interface. Make sure you fully understand the
impact of the command on your network.
Examples
# Shut down interface Tunnel 1.
<Sysname> system-view
[Sysname] interface tunnel 1
[Sysname-Tunnel1] shutdown
Related commands
display interface tunnel
source
Use source to specify the source address or source interface for the tunnel interface.
Use undo source to restore the default.
Syntax
source { ip-address | ipv6-address | interface-type interface-number }
undo source
Default
No source address or source interface is specified for the tunnel interface.
Views
Tunnel interface view
Predefined user roles
network-admin
Parameters
ip-address: Specifies the tunnel source IPv4 address.
ipv6-address: Specifies the tunnel source IPv6 address.
interface-type interface-number: Specifies the source interface. The interface must be up and must
have an IP address.
To Next Page
Loading...
Need help?
General