HPE 5920 series

189
Send VRF: 0xffff
Receive VRF: 0xffff
Table 49 Command output
Field
Description
Total RawIP socket number Total number of IPv6 RawIP sockets.
Slot ID of the IRF member device.
Creator Task name of the socket. The process number is in the square brackets.
State Socket state.
Options Socket options.
Receiving
buffer(cc/hiwat/lowat/state)
Displays receive buffer information in the following order:
• cc—Used space.
• hiwat—Maximum space.
• lowat—Minimum space.
• state—Buffer state:
 CANTSENDMORE—Unable to send data to the peer.
 CANTRCVMORE—Unable to receive data from the peer.
 RCVATMARK—Receiving tag.
 N/A—None of the above states.
Sending
buffer(cc/hiwat/lowat/state)
Displays send buffer information in the following order:
• cc—Used space.
• hiwat—Maximum space.
• lowat—Minimum space.
• state—Buffer state:
 CANTSENDMORE—Unable to send data to the peer.
 CANTRCVMORE—Unable to receive data from the peer.
 RCVATMARK—Receiving tag.
 N/A—None of the above states.
Type
Socket type:
• 1—SOCK_STREAM. This socket uses TCP to provide reliable
transmission of byte streams.
• 2—SOCK_DGRAM. This socket uses UDP to provide datagram
transmission.
• 3—SOCK_RAW. This socket allows an application to change the next
upper-layer protocol header.
• N/A—None of the above types.
Protocol Number of protocol using the socket. 58 represents ICMP.
Connection info
Connection information, including the source and destination IPv6
addresses.
Inpcb flags
Flags in the Internet PCB:
• INP_RECVOPTS—Receives IPv6 options.
• INP_RECVRETOPTS—Receives replied IPv6 options.
• INP_RECVDSTADDR—Receives destination IPv6 address.
• INP_HDRINCL—Provides the entire IPv6 header.
• INP_REUSEADDR—Reuses the IPv6 address.
• INP_REUSEPORT—Reuses the port number.
• INP_ANONPORT—Port number not specified.
• INP_PROTOCOL_PACKET—Identifies a protocol packet.
• INP_RCVVLANID—Receives the VLAN ID of the packet. Only UDP