HPE FlexNetwork 5130 EI Series Fundamentals Configuration Guide

5
Usage guidelines
• After you successfully execute a command by using a keyword alias, the system saves the
keyword, instead of its alias, to the running configuration.
• If a string you entered for a command partially matches an alias and a keyword, the command
indicated by the alias is executed. To execute the command indicated by the keyword, enter the
complete keyword.
• If a string you entered for a command partially matches multiple aliases, the system displays an
error message.
• If you enter a string that partially matches an alias and a keyword and press Tab, the keyword
indicated by the alias is displayed. Pressing Tab again displays the keyword.
Configuration procedure
To configure a command keyword alias:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enable the command
keyword alias feature.
command-alias enable
By default, the command keyword
alias feature is disabled.
3. Configure a command
keyword alias.
command-alias mapping
cmdkey alias
By default, no command keyword
alias is configured.
You must enter the cmdkey and
alias arguments in their complete
form.
4. (Optional.) Display command
keyword alias information.
display command-alias
This command is available in any
view.
Configuring and using command hotkeys
The system defines the hotkeys shown in Table 2 and provides five configurable command hotkeys.
Pressing a command hotkey is the same as entering a command.
If a hotkey is also defined by the terminal software you are using to interact with the device, the
terminal software definition takes effect.
To configure a command hotkey:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Assign a command
to a hotkey.
hotkey
{
ctrl_g
|
ctrl_l
|
ctrl_o
|
ctrl_t
|
ctrl_u
} command
By default:
• Ctrl+G is assigned the display
current-configuration command.
• Ctrl+L is assigned the display ip
routing-table command.
• Ctrl+O is assigned the undo debugging
all command.
• No command is assigned to Ctrl+T or
Ctrl+U.
3. (Optional.) Display
hotkeys.
display hotkey
Available in any view.

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English