HPE FlexNetwork 5130 EI Series Fundamentals Configuration Guide

48
Figure 18 Network diagram
Configuration procedure
# Create an ACL to permit packets sourced from Host A and Host B.
<Sysname> system-view
[Sysname] acl number 2000 match-order config
[Sysname-acl-basic-2000] rule 1 permit source 10.110.100.52 0
[Sysname-acl-basic-2000] rule 2 permit source 10.110.100.46 0
[Sysname-acl-basic-2000] quit
# Associate the ACL with the SNMP community and the SNMP group.
[Sysname] snmp-agent community read aaa acl 2000
[Sysname] snmp-agent group v2c groupa acl 2000
[Sysname] snmp-agent usm-user v2c usera groupa acl 2000
Configuring command authorization
By default, commands are available for a user depending only on that user's user roles. When the
authentication mode is scheme, you can configure the command authorization feature to further
control access to commands.
After you enable command authorization, a command is available for a user only if the user meets
the following conditions:
• Has the commensurate user role.
• Authorized to use the command by the AAA scheme.
This section provides the procedure for configuring command authorization. To make the command
authorization feature take effect, you must configure a command authorization method in ISP
domain view. For more information, see Security Configuration Guide.
Configuration procedure
To configure command authorization:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter user line view or
user line class view.
• Enter user line view:
line { first-number1
[ last-number1 ] | { aux | vty }
A setting in user line view is applied only
to the user line. A setting in user line class
view is applied to all user lines of the

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English