52
Step Command Remarks
command accounting is enabled on all
user lines in the class. You cannot
configure the
undo command
accounting
command in the view of a
user line in the class.
Configuration example
Network requirements
As shown in Figure 20, users need to log in to the device to manage the device.
Configure the device to send commands executed by users to the HWTACACS server to monitor
and control user operations on the device.
Figure 20 Network diagram
Configuration procedure
# Enable the Telnet server.
<Device> system-view
[Device] telnet server enable
# Enable command accounting for user line AUX 0.
[Device] line aux 0
[Device-line-aux0] command accounting
[Device-line-aux0] quit
# Enable command accounting for user lines VTY 0 through VTY 63.
[Device] line vty 0 63
[Device-line-vty0-63] command accounting
[Device-line-vty0-63] quit
# Create HWTACACS scheme tac.
[Device] hwtacacs scheme tac
To Next Page
Loading...
Need help?
General