39
Step Command Remarks
online users log out.
For more information about this
command, see Security Command
Reference.
10. Create a local user and
enter local user view.
local-user
user-name [
class
manage
]
By default, no local user is configured.
11. Configure a password for
the local user.
• In non-FIPS mode:
password [ { hash |
simple } password ]
• In FIPS mode:
password
The password is saved in hashed form.
By default, no password is configured
for a local user.
• In non-FIPS mode, the local user
can pass authentication after
entering the correct username and
passing attribute checks.
• In FIPS mode, the local user
cannot pass authentication.
12. Assign a user role to the
local user.
authorization-attribute
user-role
user-role
The default user role is
network-operator for a Web user.
13. Specify a service type for
the local user.
service-type
web
By default, no service type is specified
for a local user.
Displaying and maintaining Web login
Execute display commands in any view and the free web users command in user view.
Task Command
Display online Web users.
display web users
Display Web interface navigation tree information.
display web menu
Display HTTP service configuration and status information.
display ip http
Display HTTPS service configuration and status
information.
display ip https
Log off online Web users.
free web users
{
all
|
user-id
user-id |
user-name
user-name }
Web login configuration examples
HTTP login configuration example
Network requirements
As shown in Figure 13, the PC and the device can communicate over the IP network.
Configure the device to allow the PC to log in by using HTTP.
To Next Page
Loading...
Need help?
General