HPE FlexNetwork 5130 EI Series Fundamentals Configuration Guide

30
Using the device to log in to a Telnet server
You can use the device as a Telnet client to log in to a Telnet server. If the server is located in a
different subnet than the device, make sure the two devices have routes to reach each other.
Figure 7 Telnetting from the device to a Telnet server
To use the device to log in to a Telnet server:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. (Optional.) Specify the
source IPv4 address or
source interface for
outgoing Telnet packets.
telnet client source
{
interface
interface-type interface-number |
ip
ip-address }
By default, no source IPv4
address or source interface is
specified, and the primary IPv4
address of the outbound
interface is used as the source
address for outgoing Telnet
packets.
3. Exit to user view.
quit
N/A
4. Use the device to log in to
a Telnet server.
• Log in to an IPv4 Telnet server:
telnet remote-host [ service-port ]
[ source { interface interface-type
interface-number | ip ip-address } ]
[ dscp dscp-value ]
• Log in to an IPv6 Telnet server:
telnet ipv6 remote-host [ -i
interface-type interface-number ]
[ port-number ] [ dscp dscp-value ]
N/A
Logging in through SSH
SSH offers a secure method to remote login. By providing encryption and strong authentication, it
protects devices against attacks such as IP spoofing and plain text password interception. For more
information, see Security Configuration Guide.
You can use an SSH client to log in to the device for remote management, or use the device as an
SSH client to log in to an SSH server.
By default, SSH login is disabled on the device. To log in to the device through SSH, you must log in
to the device through any other method and configure SSH login on the device first.
Configuring the device as an SSH server
This section provides the configuration procedure for when the SSH client authentication method is
password. For more information about SSH and publickey authentication configuration, see Security
Configuration Guide.
To configure SSH login on the device:

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English