HPE FlexNetwork 5130 EI Series Fundamentals Configuration Guide

47
Step Command Remarks
2. Configure the
SNMP access
right.
• (Method 1.) Create an SNMP community and specify
ACLs for the community:
{ In VACM mode:
snmp-agent community { read | write } [ simple |
cipher ] community-name [ mib-view view-name ]
[ acl acl-number | acl ipv6 ipv6-acl-number ] *
{ In RBAC mode:
snmp-agent community [ simple | cipher ]
community-name user-role role-name [ acl
acl-number | acl ipv6 ipv6-acl-number ] *
• (Method 2.) Create an SNMPv1/v2c group and add a
user to the group, specifying ACLs for the group and
user:
a. snmp-agent group { v1 | v2c } group-name
[ read-view view-name ] [ write-view view-name ]
[ notify-view view-name ] [ acl acl-number | acl ipv6
ipv6-acl-number ] *
b. snmp-agent usm-user { v1 | v2c } user-name
group-name [ acl acl-number | acl ipv6
ipv6-acl-number ] *
For more
information about
SNMP, see
Network
Management and
Monitoring
Configuration
Guide.
To control SNMPv3 access, configure ACLs and complete the following configuration:
Step Command Remarks
1. Enter system
view.
system-view
N/A
2. Create an
SNMPv3 group,
specifying ACLs
for the group.
snmp-agent group v3
group-name [
authentication
|
privacy
] [
read-view
view-name ] [
write-view
view-name ]
[
notify-view
view-name ] [
acl
acl-number |
acl ipv6
ipv6-acl-number ] *
N/A
3. Create an
SNMPv3 user,
specifying ACLs
for the user.
• In VACM mode:
snmp-agent usm-user v3 user-name group-name
[ remote { ip-address | ipv6 ipv6-address } ] [ { cipher |
simple } authentication-mode { md5 | sha }
auth-password [ privacy-mode { aes128 | 3des |
des56 } priv-password ] ] [ acl acl-number | acl ipv6
ipv6-acl-number ] *
• In RBAC mode:
snmp-agent usm-user v3 user-name user-role
role-name [ remote { ip-address | ipv6 ipv6-address } ]
[ { cipher | simple } authentication-mode { md5 | sha }
auth-password [ privacy-mode { aes128 | 3des |
des56 } priv-password ] ]
[ acl acl-number | acl ipv6
ipv6-acl-number ] *
For more
information about
SNMP, see
Network
Management and
Monitoring
Configuration
Guide.
Configuration example
Network requirements
As shown in Figure 18, the device is running SNMP.
Configure the device to allow Host A and Host B to access the device through SNMP.

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English