HPE FlexNetwork 5130 EI Series Fundamentals Configuration Guide

21
Logging in through the console port locally
You can connect a terminal to the console port of the device to log in and manage the device, as
shown in Figure 6. Fo
r the login procedure, see "Logging in through the console port for the first
device access."
Figure 6 Logging in through the console port
By default, console login is enabled and does not require authentication. To improve device security,
configure password or scheme authentication and assign user roles immediately after you log in to
the device for the first time.
To configure console login, complete the following tasks:
Task Remarks
(Required.) Configuring login authentication:
• Disabling authentication for console login
• Configuring password authentication for console login
• Configuring scheme authentication for console login
Configure one authentication mode as
required.
In FIPS mode, only the scheme
authentication mode is supported.
(Optional.) Configuring common AUX line settings N/A
The console login configuration is effective only for users who log in after the configuration is
completed.
Before using multiple devices to form an IRF fabric, enter AUX line class view on each device and
perform the following tasks:
• Disable authentication.
• Assign the user role network-admin.
Disabling authentication for console login
Step Command Remarks
3. Enter system
view.
system-view
N/A
4. Enter AUX line
view or class
view.
• Enter AUX line view:
line aux first-number
[ last-number ]
• Enter AUX line class view:
line class aux
A setting in user line view is applied only to
the user line. A setting in user line class
view is applied to all user lines of the class.
A non-default setting in either view takes
precedence over a default setting in the
other view. A non-default setting in user
line view takes precedence over a
non-default setting in user line class view.
A setting in user line view takes effect
immediately and affects the online user. A
setting in user line class view does not
affect online users and takes effect only for
users who log in after the configuration is
completed.
5. Disable authentication-mode none
By default, authentication is disabled for

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English