HPE FlexNetwork 5130 EI Series - Page 89

82
Step Command Remarks
1. Enter system view.
system-view
N/A
2. (Optional.) Specify a source
IP address for outgoing FTP
packets.
ftp client source
{
interface
interface-type interface-number |
ip
source-ip-address }
By default, no source IP
address is specified, and the
primary IP address of the
output interface is used as
the source IP address.
3. Return to user view.
quit
N/A
4. Log in to the FTP server.
• (Method 1.) Log in to the FTP
server from user view:
ftp ftp-server [ service-port ][ dscp
dscp-value | source { interface
{ interface-name | interface-type
interface-number } | ip
source-ip-address } ] *
• (Method 2.) Log in to the FTP
server from FTP client view:
a. ftp
b. open server-address
[ service-port ]
The source IP address
specified in the
ftp
command
takes precedence over the
one set by the
ftp client
source
command.
To establish an IPv6 FTP connection:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. (Optional.) Specify the
source IPv6 address for FTP
packets sent by the FTP
client.
ftp client ipv6 source
{
interface
interface-type interface-number |
ipv6
source-ipv6-address }
By default, no source IPv6
address is specified. The source
address is automatically selected
as defined in RFC 3484.
3. Return to user view.
quit
N/A
4. Log in to the FTP server.
• (Method 1.) Log in to the FTP
server from user view:
ftp ipv6 ftp-server
[ service-port ] [ dscp
dscp-value | source
{ interface interface-type
interface-number | ipv6
source-ipv6-address } ] * [ -i
interface-type
interface-number ]
• (Method 2.) Log in to the FTP
server from FTP client view:
a. ftp ipv6
b. open server-address
[ service-port ]
The source IP address specified
in the
ftp ipv6
command takes
precedence over the one set by
the
ftp client ipv6 source
command.