3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5.
Remove the server from the rack.
6. Remove the access panel.
7. Install the intrusion detection switch:
a. Connect the intrusion detection switch cable.
b. Press the switch towards the chassis.
c. Slide the switch into the slot on the chassis.
8.
Install the access panel.
9.
Install the server into the rack.
10.
Connect all peripheral cables to the server.
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13.
Power up the server.
14. If removed, install the bezel.
The installation is complete.
102
Hardware options installation
To Next Page
Loading...
