HPE ProLiant DL325 Gen10 Plus

NOTE: HPE ProLiant DL325 Gen10 Plus Server - A legacy OS booting device is only supported on a specific drive
location.
For the server with an embedded SATA configuration, when the embedded SATA port is connected under Legacy BIOS
mode, the drive bay number and the port number do not match. The operating system must be installed on the drive with
the lowest port number to successfully boot.
The following table provides information about the aected configurations and the required OS boot drive location. 12
LFF and 24 SFF configurations have no impact as the embedded SATA is not supported.
Embedded SATA
configuration
OS boot drive location Port Number
4LFF Box 1, Bay 1 Port 5
8LFF Box 2, Bay 1 Port 1
8SFF Box 1, Bay 5 Port 1
8SFF + 2SFF Box 1, Bay 5 (if OS is to be installed in 8SFF)
Box 2, Bay 2 (if OS is to be installed in 2SFF)
Port 1
Port 7
8SFF + Dual uFF Box 1, Bay 5 (if OS is to be installed in 8SFF)
Box 2, Bay 102 (if OS is to be installed in uFF)
Port 1
Port 5
20SFF (8 + 2 SATA/8 + 2
SATA)
Box 4, Bay 1 (if OS is to be installed in 2SFF) Port 1
To identify exact drive bay location, see Drive box identification and Drive bay numbering.
For more information, see the customer advisory.
8.
Deploy an OS or virtualization software. Do one of the following:
• Press F10 at the POST screen.
For Intelligent Provisioning 330 and later, you are prompted to select whether you want to enter the Intelligent
Provisioning or HPE SMB Setup mode. After you have selected a mode, you must reprovision the server to change
the mode that launches when you boot to F10.
• Manually deploy an OS.
a.
Insert the installation media.
For remote management, click Virtual Drives in the iLO remote console to mount images, drivers, or files to a
virtual folder. If a storage driver is required to install the OS, use the virtual folder to store the driver.
b. Press F11 at boot screen and select the boot device.
c. After the OS installed,
update the drivers.
Register the server
9. To experience quicker service and more
eicient support, register the server at the HPE website:
https://myenterpriselicense.hpe.com
Setup
57