HPE ProLiant DL325 Gen11 - Results; Optical drive replacement; Removing and replacing an optical drive from the LFF drive configuration; Prerequisites

ResultsResults
To replace the component, reverse the removal procedure.
Optical drive replacementOptical drive replacement
SubtopicsSubtopics
Removing and replacing an optical drive from the LFF drive configurationRemoving and replacing an optical drive from the LFF drive configuration
Removing and replacing the optical drive from the SFF drive configurationRemoving and replacing the optical drive from the SFF drive configuration
Removing and replacing an optical drive from the LFF drive configurationRemoving and replacing an optical drive from the LFF drive configuration
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
Phillips No. 1 screwdriver
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION:CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with
either a component or a blank.
ProcedureProcedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, open the cable management arm.
HPE ProLiant DL325 Gen11 Server Maintenance and Service Guide 106