10. If installed, remove the expansion card .
11. Remove the riser board.
Retain all screws. These screws will be used to secure the new riser board spare.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the internal USB deviceRemoving and replacing the internal USB device
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm.
To Next Page
Loading...
