ItemItem LEDLED StatusStatus DescriptionDescription
1 Management Port Activity LED Off No activity
Flashing Passing traffic; flashing frequency indicates traffic intensity
2 Management Port Link LED Off A link has not been established
Solid green Valid Ethernet link
3 SFP Port 1 Link/Activity LED Off A link has not been established
Solid green Valid Ethernet link
Flashing green Passing traffic; flashing frequency indicates traffic intensity
Solid amber Link fault
4 SFP Port 2 Link/Activity LED Off A link has not been established
Solid green Valid Ethernet link
Flashing green Passing traffic; flashing frequency indicates traffic intensity
Solid amber Link fault
5 System status LED Off System is not powered
Solid amber Power is up, software has not booted yet
Solid green System is up and fully operational
HPEHPE Trusted Platform Module 2.0 Trusted Platform Module 2.0 guidelines guidelines
CAUTION:CAUTION:
Always observe the TPM guidelines in this section. Failure to follow these guidelines can cause hardware damage or
halt data access.
If you do not follow procedures for modifying the server and suspending or disabling the TPM in the OS, an OS that is
using TPM might lock all data access. This includes updating system or option firmware, replacing hardware such as the
system board and drives, and modifying TPM OS settings.
Changing the TPM mode after installing an OS might cause problems, including loss of data.
Hewlett Packard EnterpriseHewlett Packard Enterprise SPECIAL REMINDER: SPECIAL REMINDER: Before enabling TPM functionality on this system, you must ensure that your intended use
of TPM complies with relevant local laws, regulations and policies, and approvals or licenses must be obtained if applicable.
When the embedded TPM is enabled, the Trusted Platform Module operates in TPM 2.0 mode.
Use the UEFI System Utilities to configure the TPM. From the System Utilities screen, select System Configuration > BIOS/Platform
Configuration (RBSU) > Server Security > Trusted Platform Module options. For more information, see the UEFI user guide:
To Next Page
Loading...
