HPE ProLiant DL325 Gen11 - Results; Removing and replacing a hot-plug SAS, SATA or NVMe drive; About this task

2. Press the bezel release latch (callout 1), and then pivot the bezel open (callout 2).
3. Release the right side of the bezel from the front panel (callout 3).
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing a hot-plug SAS, SATA or NVMe driveRemoving and replacing a hot-plug SAS, SATA or NVMe drive
About this taskAbout this task
HPE ProLiant DL325 Gen11 Server Maintenance and Service Guide 66