IMPORTANT:IMPORTANT:
When you replace a transceiver with another of a different type, the server might retain selected port-specific configuration
settings that were configured for the replaced transceiver. Be sure to validate or reconfigure port settings as required.
Removing and replacing a transceiverRemoving and replacing a transceiver
PrerequisitesPrerequisites
Before replacing a transceiver, review the following:
Transceiver warnings and cautions
Transceiver documentation for specific operational and cabling requirements
ProcedureProcedure
1. If installed, open the cable management arm.
2. Disconnect the network cable from the transceiver.
3. Slide the transceiver out of the network adapter port.
See the transceiver documentation for model-specific release mechanism for removing the transceiver.
To Next Page
Loading...
