ItemItem DescriptionDescription
1 Slot 1 PCIe5 x16
2 NS204i-u boot device (optional)
3 Slot 2 PCIe5 x16 (optional)
4 Slot 2 PCIe5 x16 (optional)
5 Flexible Slot power supply 2 (optional)
6 Flexible Slot power supply 1
7 VGA port
8 Slot 22 OCP PCIe5 x8
9 Serial port (optional)
10 iLO management port
11 USB 3.2 Gen1 ports
12 Slot 21 OCP PCIe5 x8
This riser slot is in the primary riser cage.
This option is in the NS204i-u + low-profile riser cage.
This riser slot locates in the NS204i-u + low-profile riser cage and supports half-height half-length (low-profile) expansion card.
This riser slot is in the secondary riser cage.
In Slot 21 OCP, the OCP bandwidth upgrade cable is required to support a x16 OCP expansion option.
SubtopicsSubtopics
Display device setupDisplay device setup
Display device setupDisplay device setup
This server supports both VGA port and DisplayPort 1.1a. Before connecting a display device to this server, review the information below.
Whenever possible, use the same display connection type. For example, if your PC or monitor only has a VGA output, connect it to the
server VGA port. Use of any kind of adapter or converter cable or dongle might lead to decreased display quality or a lag over the
connection.
DisplayPort connection: When connecting an HDMI or DVI display to the DisplayPort, use an active type adapter. Passive type adapter—
marked with the DP++ symbol—is not supported.
Display output modes:
If you connect two display devices to the VGA port and DisplayPort, the same image is shown on both devices—screen mirroring
mode.
1
2
3
4
5
1
2
3
4
5
To Next Page
Loading...
