SubtopicsSubtopics
Removing and replacing the boot device cage assemblyRemoving and replacing the boot device cage assembly
Removing and replacing a hot-plug boot device carrierRemoving and replacing a hot-plug boot device carrier
Removing and replacing a non-hot-plug boot device carrierRemoving and replacing a non-hot-plug boot device carrier
Removing and replacing a hot-plug boot device driveRemoving and replacing a hot-plug boot device drive
Removing and replacing a non-hot-plug boot device driveRemoving and replacing a non-hot-plug boot device drive
Removing and replacing the Removing and replacing the boot deviceboot device cage assembly cage assembly
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Back up all server data.
2. Power down the server.
3. If installed, open the cable management arm.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
To Next Page
Loading...
