5. If you are removing the second boot device carrier, repeat steps 3 and 4 on the lower boot device carrier slot.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing a non-hot-plug Removing and replacing a non-hot-plug boot deviceboot device carrier carrier
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a Phillips No. 1 screwdriver available.
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Back up all server data.
2. Power down the server.
3. If installed, open the cable management arm.
To Next Page
Loading...
