HPE ProLiant DL325 Gen11 - Results; Removing and replacing the expansion card from the HPE NS204 i Boot Device riser cage; Prerequisites; About this task

10. Remove the expansion card:
a. Remove the screw (callout 1).
Retain the screw. The screw will be used to secure the new expansion card spare.
b. Press and hold the release latch (callout 2).
c. Detach the expansion card from the riser (callout 3).
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the expansion card from the Removing and replacing the expansion card from the HPE NS204i Boot DeviceHPE NS204i Boot Device riser cage riser cage
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm.
HPE ProLiant DL325 Gen11 Server Maintenance and Service Guide 150