Tri-mode controller support for x1 U.3 NVMe, SAS, and SATA drives. System board connection supports SATA drives only.
CPU direct attach or tri-mode controller support for x4 U.3 NVMe or x1 SAS and SATA drives.
CPU direct attach or tri-mode controller support for x4 U.2 NVMe drives.
Fan numberingFan numbering
To provide sufficient airflow to the system, the server is by default populated by seven fans. The fans can either be standard fan ( P58461-
B21) or high performance fan ( P58462-B21). Mixed fan configuration is not supported.
The arrow points to the front of the server.
Fan and heatsink requirementsFan and heatsink requirements
CAUTION:CAUTION: To maintain proper system cooling, install the correct fan and heatsink types required for specific hardware
configurations.
CAUTION:CAUTION: To maintain proper system cooling, when a 25 Gb or faster Ethernet / InfiniBand adapter / HPE Storage
Networking NVMe-oF Offload Adapter / HPE NS204i Boot Device is installed in any configuration, make sure to use high
performance fans.
The system-operating temperature for most components installed in this server is at standard temperature ( 10°C to 35°C / 50°F to 95°F ).
However, system performance during standard operating support may be reduced if operating with above 30°C (86°F). The following table
contains the allowed hardware configurations that the system can be run at 30°C (86°F) without system performance degradation.
Drive configurationsDrive configurations Processor TDPProcessor TDP Fan typeFan type Heatsink typeHeatsink type
4 LFF drives
8 SFF drives
10 SFF drives
200 W–240 W Standard fan Standard heatsink
260 W–300 W High performance fan High performance heatsink
320 W–400 W Liquid cooling fan Liquid cooling heatsink
Option kit: P58461-B21
Option kit: P58456-B21
Option kit: P58462-B21
Option kit: P58457-B21
Option kit: P59668-B21
Option kit: P58463-B21
1
2
3
1 2
3 4
5 6
1
2
3
4
5
6
To Next Page
Loading...
