ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the secondary low-profile one-slot PCIe5 x16 riser boardRemoving and replacing the secondary low-profile one-slot PCIe5 x16 riser board
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this taskAbout this task
CAUTION:CAUTION:
Before replacing a DIMM, backplane, expansion card, riser board, or other similar PCA components due to a perceived
hardware error, make sure first that the component is firmly seated in the slot.
When installing the replacement component:
Observe antistatic precautions.
Handle the PCA only along the edges.
Do not touch the components and connectors on the PCA.
Do not bend or flex the PCA.
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm.
To Next Page
Loading...
