ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the one-slot primary/secondary riser cageRemoving and replacing the one-slot primary/secondary riser cage
About this taskAbout this task
WARNING:WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components to
cool before touching them.
CAUTION:CAUTION:
To prevent damage to electrical components, properly ground the server before beginning any installation, removal, or
replacement procedure. Improper grounding can cause electrostatic discharge.
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm.
To Next Page
Loading...
