HPE ProLiant DL325 Gen11 - Results; HPE NS204 i-u Boot Device replacement

a. Rotate the locking pin to the open (vertical) position (callout 1).
b. Detach the M.2 pass-through card assembly from the chassis (callout 2).
10. Remove a M.2 SSD.
Retain the screw. This screw will be used to secure the new M.2 SSD.
11. If you are replacing the second M.2 SSD, repeat step 11.
ResultsResults
To replace the component, reverse the removal procedure.
HPE NS204i-u Boot Device HPE NS204i-u Boot Device replacementreplacement
HPE ProLiant DL325 Gen11 Server Maintenance and Service Guide 159