Retain these SSDs and mounting screw for installation onto the new boot device carrier.
14. If you are removing the second boot device carrier, repeat steps 3 and 4 on the lower boot device carrier slot.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing a hot-plug Removing and replacing a hot-plug boot deviceboot device drive drive
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a Phillips No. 1 screwdriver available.
About this taskAbout this task
CAUTION:CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with
either a component or a blank.
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Back up all server data.
2. If installed, open the cable management arm.
To Next Page
Loading...
