CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack.
6. Place the server on a flat, level work surface.
7. Remove the access panel.
8. Do one of the following:
Remove the secondary riser cage blank
Remove the secondary riser cage
Remove the NS204i-u + secondary low-profile riser cage
9. Disconnect the serial port cable from the system board .
10. Remove the serial port:
a. Remove the hex screws (callout 1).
Retain screws for future use.
b. Detach the serial port from the rear panel (callout 2).
To Next Page
Loading...
