3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack.
6. Place the server on a flat, level work surface.
7. Remove the access panel.
8. Remove the DIMM blank:
CAUTION:CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless all DIMM slots have either a DIMM
or a DIMM blank installed.
a. Open the DIMM slot latches (callout 1).
b. Lift the blank from the DIMM slot (callout 2).
To Next Page
Loading...
