5. Remove the server from the rack.
6. Place the server on a flat, level work surface.
7. If installed, remove the front bezel .
8. Remove the access panel.
9. Disconnect the front I/O cable from the system board .
10. Remove the right chassis ear assembly:
a. Remove T-10 screws (callouts 1 and 2).
Retain the screws. These screws will be used to secure the new right chassis ear assembly spare.
b. Pull the right ear and front I/O port assembly simultaneously (callout 3).
LFF drive configuration
SFF drive configuration
To Next Page
Loading...
