3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack.
6. Place the server on a flat, level surface.
7. To remove the sliding rails, do the following:
a. Pull and hold the release latch (callout 1).
b. Slide the rail towards the front panel and pull it from the server (callout 2).
c. Repeat steps a and b to remove the other rail.
8. To remove the rack mounting rails, do the following:
To Next Page
Loading...
