Huawei 5288 V3 V100R003 - Installing an os; Optional) Configuring the Boot from Iscsi Function for an SP230 Flexible NIC

i. Set the parameter in IPV4 configuration and IPV6 Configuration for the iBMC
management network port in the same way.
j. Press F10 to save settings and exit.
5.8 Installing an OS
The 5288 V3 is compatible with different types of OSs, including Windows, SUSE Linux
Enterprise Server (SLES), and Red Hat Enterprise Linux (RHEL). For details, see Huawei
Server Compatibility Checker.
The OS installation method varies according to the OS type. For details about the installation
procedure, see HUAWEI Server OS Installation Guide.
5.9 (Optional) Configuring the Boot from iSCSI Function
for an SP230 flexible NIC
An SP230 supports boot from PXE or iSCSI. Boot from PXE is enabled by default. To boot
from iSCSI, enable it first.
NOTE
Before you configure the server to boot from iSCSI, ensure that the operating system (OS) of the server
supports the iSCSI protocol stack and has the iSCSI driver.
Before configuring the boot from iSCSI function, load the optional ROM for iSCSI. For
details, see "Upgrading the Intel X540 flexible NIC Firmware" in the HUAWEI Server
Firmware Upgrade Guide.
5288 V3 Server
User Guide
5 Configuring the 5288 V3
Issue 26 (2018-11-19) Copyright © Huawei Technologies Co., Ltd. 112