Figure 7-52 Installing the TPM
Step 5 Tighten the screw on the TPM using a Phillips screwdriver. See step (2) in Figure 7-52.
Step 6 Install the riser card above the TPM. For details, see 7.20 Installing a Riser Card.
Step 7 Install the chassis cover. For details, see 7.12 Installing the Chassis Cover.
Step 8 Install the 5288 V3. For details, see 3.4 Installing the Server.
Step 9 Connect all internal cables such as power and network cables. For details, see 3.5 Connecting
External Cables.
Step 10 Power on the 5288 V3. For details, see 4.1 Powering On the Server.
----End
7.25 Removing the Internal USB Flash Drive
Remove the USB flash drive before replacing it with a new one.
Procedure
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
Step 2 Determine the rack number and chassis number of the server to be removed, and label its
panel to prevent misoperations.
Step 3 Power off the 5288 V3. For details, see 4.2 Powering Off the Server.
Step 4 Remove all external cables such as power and network cables.
Step 5 Remove the 5288 V3 and put it on an ESD desktop. For details, see 3.6 Removing the
Server.
5288 V3 Server
User Guide
7 Replacing Parts
Issue 26 (2018-11-19) Copyright © Huawei Technologies Co., Ltd. 166
To Next Page
Loading...
