Figure 9-2 iBMC Configuration
----End
Querying the IP Address on the iBMC CLI
Step 1 Log in to the iBMC CLI.
For details, see 9.3 Logging In to the iBMC CLI.
Step 2 Run the ipmcget –d ipinfo command.
For details, see HUAWEI Rack Server iBMC User Guide.
----End
9.2 Logging In to the iBMC WebUI
Log in to the iBMC WebUI using a PC that has Windows 7 and Internet Explorer 8.0
installed.
Before using the remote control function, ensure that the OS, browser, and Java Runtime
Environment (JRE) of the required versions have been installed on the local PC. For details
about software versions, see HUAWEI Rack Server iBMC User Guide.
Ensure that the local PC meets the following networking conditions:
l The local PC is connected to the iBMC management network port on the server by using
a network cable.
l The IP addresses of the local PC and the iBMC management network port are on the
same network segment.
5288 V3 Server
User Guide
9 Common Operations
Issue 26 (2018-11-19) Copyright © Huawei Technologies Co., Ltd. 246
To Next Page
Loading...
