Figure 7-35 Pulling out the mainboard frame
Step 16 Remove the cable to be removed.
Step 17 Place the removed cable in an ESD bag.
----End
7.18 Installing an Internal Cable
Install an internal cable to replace the original one.
Procedure
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
Step 2 Remove the cable to be replaced. For details, see 7.17 Removing an Internal Cable.
Step 3 Take a spare cable out of the ESD bag.
Step 4 Connect one end of the spare cable to the hard disk backplane.
Step 5 Determine whether to install the mainboard frame.
l If yes, go to Step 6.
l If no, go to Step 8.
Step 6 Press and hold down the release spring and push the mainboard frame in the arrow direction
until it cannot move forward. See Figure 7-36.
5288 V3 Server
User Guide
7 Replacing Parts
Issue 26 (2018-11-19) Copyright © Huawei Technologies Co., Ltd. 151
To Next Page
Loading...
