Figure 7-100 Removing an SD card
Step 11 Remove the SD card from the mezzanine card. See step (2) in Figure 7-100.
Step 12 Place the removed SD card in an ESD bag.
----End
7.48 Installing an SD Card
Install an SD card to replace the original one.
One or two SD cards can be installed on a server and are monitored by the iBMC. After the
iBMC initialization is complete, two SD cards are configured as a RAID 1 array when being
detected. You can view the information about the SD cards and RAID 1 array on the iBMC
WebUI by choosing System Info > Other, but cannot modify the configuration or manually
configure them. The two SD cards do not work in active/standby mode and data
synchronization between them may result in data overwriting. It is recommended that you
ensure that the SD card to be added contains no data, avoiding data synchronization
exceptions.
NOTE
After replacing the faulty SD card, wait for at least 60 minutes for the RAID 1 rebuild to complete
before performing other operations.
5288 V3 Server
User Guide
7 Replacing Parts
Issue 26 (2018-11-19) Copyright © Huawei Technologies Co., Ltd. 216
To Next Page
Loading...
