Step 8 Install the chassis cover. For details, see 7.12 Installing the Chassis Cover.
Step 9 Install the 5288 V3. For details, see 3.4 Installing the Server.
Step 10 Connect all internal cables such as power and network cables. For details, see 3.5 Connecting
External Cables.
Step 11 Power on the 5288 V3. For details, see 4.1 Powering On the Server.
----End
7.21 Removing a PCIe Card
A PCIe card can be installed on the mainboard or on a riser card. The following describes
how to remove a PCIe card from the mainboard or from a riser card.
7.21.1 Removing a PCIe Card from a Riser Card
Remove a PCIe card before replacing it with a new one or removing the riser card where it is
installed.
Procedure
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
Step 2 Determine the rack number and chassis number of the server to be removed, and label its
panel to prevent misoperations.
Step 3 Power off the 5288 V3. For details, see 4.2 Powering Off the Server.
Step 4 Remove all external cables such as power and network cables.
Step 5 Remove the 5288 V3 and put it on an ESD desktop. For details, see 3.6 Removing the
Server.
Step 6 Remove the chassis cover. For details, see 7.11 Removing the Chassis Cover.
Step 7 Remove all cables from the riser card if any.
Step 8 Remove a riser card tray. Lift the riser card tray. See Figure 7-44.
5288 V3 Server
User Guide
7 Replacing Parts
Issue 26 (2018-11-19) Copyright © Huawei Technologies Co., Ltd. 158
To Next Page
Loading...
Need help?
General