Huawei 5288 V3 V100R003 - 7.31 Removing the Standard RAID Controller Card

Step 12 Power on the 5288 V3. For details, see 4.1 Powering On the Server.
Step 13 Log in to the RAID configuration screen to check whether RAID configuration needs to be
imported or activated. For details, see the HUAWEI V2&V3 Server RAID Controller Card
User Guide.
----End
7.31 Removing the Standard RAID Controller Card
Remove the standard RAID controller card before replacing it with a new one.
Procedure
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
Step 2 Determine the rack number and chassis number of the server to be removed, and label its
panel to prevent misoperations.
Step 3 Power off the 5288 V3. For details, see 4.2 Powering Off the Server.
Step 4 Remove all external cables such as power and network cables.
Step 5 Remove the 5288 V3 and put it on an ESD desktop. For details, see 3.6 Removing the
Server.
Step 6 Remove the chassis cover. For details, see 7.11 Removing the Chassis Cover.
Step 7 Remove the riser card if the RAID controller card to be removed is installed on a riser card.
For details, see 7.19 Removing the Riser Card.
Step 8 Check the chip model of the RAID controller card to be removed.
If the chip model of the RAID controller card to be removed is LSI SAS3108, remove the
trans flash module (TFM) first. For details, see 7.34 Removing the Supercapacitor
(Standard RAID Controller Card).
If the chip model of the RAID controller card to be removed is PM8060, remove the cable
between the supercapacitor and the RAID controller card. For details, see 7.34 Removing the
Supercapacitor (Standard RAID Controller Card).
Step 9 Remove the SAS cables from the standard RAID controller card.
Step 10 Remove the standard RAID controller card.
l For details about how to remove a standard RAID controller card on the mainboard, see
7.21.2 Removing a PCIe Card from the Mainboard.
l For details about how to remove a standard RAID controller card on a riser card, see
7.21.1 Removing a PCIe Card from a Riser Card.
Step 11 Place the removed standard RAID controller card in an ESD bag.
----End
7.32 Installing the Standard RAID Controller Card
Install a standard RAID controller card replace the original one.
5288 V3 Server
User Guide
7 Replacing Parts
Issue 26 (2018-11-19) Copyright © Huawei Technologies Co., Ltd. 174