Step 2 Choose Config > Security Enhance.
Step 3 Select Enable for Password Complexity Check.
The system will perform a password complexity check when a new password is set.
Step 4 Choose Config > Local User, as shown in Figure 5-15.
Figure 5-15 Local User page
Step 5 Click next to the user whose password needs to be changed.
Step 6 Change the password as prompted.
l When the password complexity check function is disabled, the password can be empty or
a string of any characters fewer than 20 characters.
l When the password complexity check function is enabled, the password must meet the
following requirements:
– Must contain 8 to 20 characters.
– Must contain at least one space or one of the following special characters:
`~!@#$%^&*()-_=+\|[{}];:'",<.>/?
– Must contain at least two types of the following characters:
n Uppercase letters
n Lowercase letters
n Digits
– Must not be same as the user name or the reverse of the user name.
----End
5.7 Setting the Management Network Port IP Address
Set the management network IP address through the iBMC WebUI, BIOS, and LCD of the
iBMC. You can also set the IP address by running the ipaddr command on the iBMC CLI of
the iBMC. For details, see HUAWEI Rack Server iBMC User Guide.
5288 V3 Server
User Guide
5 Configuring the 5288 V3
Issue 26 (2018-11-19) Copyright © Huawei Technologies Co., Ltd. 108
To Next Page
Loading...
