Figure 7-77 Installing a heat sink
Step 14 Use a Phillips screwdriver to tighten one pair of diagonally opposite screws on the heat sink
halfway and then tighten the other pair of screws. See step (2) in Figure 7-77.
Step 15 Install the air duct. For details, see 7.14 Installing the Air Duct.
Step 16 Install the chassis cover. For details, see 7.12 Installing the Chassis Cover.
Step 17 Install the 5288 V3. For details, see 3.4 Installing the Server.
Step 18 Connect all internal cables such as power and network cables. For details, see 3.5 Connecting
External Cables.
Step 19 Power on the 5288 V3. For details, see 4.1 Powering On the Server.
----End
7.39 Removing a DIMM
Remove a DIMM before replacing it with a new one.
Procedure
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
Step 2 Determine the rack number and chassis number of the server to be removed, and label its
panel to prevent misoperations.
Step 3 Power off the 5288 V3. For details, see 4.2 Powering Off the Server.
Step 4 Remove all external cables such as power and network cables.
5288 V3 Server
User Guide
7 Replacing Parts
Issue 26 (2018-11-19) Copyright © Huawei Technologies Co., Ltd. 192
To Next Page
Loading...
