Table 2-3 Ports on the front panel
Port Type Quantity Description
USB port USB 2.0 2 The USB ports are
connected to USB devices.
NOTE
Before connecting to an
external USB device, check
that the USB device operates
properly. A server may fail if it
is connected to an abnormal
USB device.
Table 2-4 Ports on the rear panel
Port
Type Quantity Description
VGA port DB15 1 The VGA port is used to
connect a terminal, such as a
monitor or KVM.
USB port USB 3.0 2 The USB ports are
connected to USB devices.
NOTE
Before connecting to an
external USB device, check
that the USB device operates
properly. A server may fail if it
is connected to an abnormal
USB device.
USB 3.0 is disabled by default.
You can enable it on the BIOS
as required.
Management
network port (Mgmt)
Ethernet port 1 The 1000 Mbit/s Ethernet
port is used to manage the
server.
Serial port DB9 1 A three-pin serial port (that
contains only the PIN2 RX,
PIN3 TX, and PIN5 GND
signals in the DB9
connector, no signals in
other pins). The default
baud rate is 115200 bit/s.
The serial port is used as the
system serial port by
default. You can set it as the
iBMC serial port by using
the iBMC command. The
port is used for debugging.
5288 V3 Server
User Guide
2 Product Overview
Issue 26 (2018-11-19) Copyright © Huawei Technologies Co., Ltd. 15
To Next Page
Loading...
