Figure 5-47 Removing a door status sensor
Step 4 Install a new door status sensor.
Step 5 Install the new door status sensor by performing the steps above in reverse order.
Step 6 Check whether the new door status sensor works properly. If the status
information of the door status sensor is displayed on the main screen of the
management system client after you open or close the corresponding cabinet
door, the new door status sensor works properly.
----End
5.4.3.7 Replacing a Cabinet Electronic Lock
Impact on the System
The electronic lock of the cabinet cannot be used.
Preparations
● Material: electronic lock
Procedure
Step 1 Open the cabinet door, and disconnect the monitoring cable from the electronic
lock.
Step 2 Remove the electronic lock.
FusionModule2000 Smart Modular Data Center
Maintenance Guide (Fusion Module Actuator) 5 Parts Replacement
Issue 01 (2020-12-25) Copyright © Huawei Technologies Co., Ltd. 96
To Next Page
Loading...
Need help?
General